CARRcrete PROseal is a highly advanced penetrating stain resistor and sealer for polished concrete flooring projects. Being solvent based PROseal is easy to work with on both small and large projects which require a level of finish superior to that offered by even the highest quality acrylic guard coats.
The impregnating action of this advanced concrete sealer allows the protection to soak deep into the surface, where it coats the ingredients of the concrete mix.
The initial coats of this concrete sealer soak into the surface of the concrete, coating the pores to increase the surface tension and thus providing useful stain resistance and reaction time.
Subsequent coats can be used as a micro guard for extra protection. PROseal applies much thinner than a standard guard product and can be diamond burnished to a high gloss, high clarity finish without any of the plastic eggshell look associated with acrylic guard products.
For best results
- Ensure concrete surface is mechanically diamond polished
- Surface has been thoroughly cleaned
- Surface is completely dry
- Allow at least 2 hours between coats (to prevent dissolving previous coats)
How to apply PROseal
- Apply in thin coats with a microfibre roller, microfibre applicator or paint pad
- DO NOT spray
- Diamond burnish between coats (ONLY if left to dry overnight or for longer than 4 hours)
- Continue to build coats and burnish as required
- Solvent based, low odour formula
- Designed for mechanically polished concrete
- Penetrates the surface
- Increases gloss when buffed/burnished
- Increases stain resistance
- Higher clarity finish
- 1 litre will yield approximately 10 square metres**
** Dependant on surface porosity